Safety operation rules for purlin machine
Equipment before use, to check whether the connection is reliable, installation bolts, nuts are tightened, the left and right chassis should be added sufficient lubrication oil to start the machine for commissioning.
The mold used in this machine requires an upper die and six of the same size of the next mold, the first installation of the upper die and a lower mold, the lower die is installed directly on the six-square wheel workbench, the upper die is mounted on the bottom of the sliding seat, and the appropriate thickness of the plate is placed to ensure that the upper and lower die are closed evenly, and the distance between the upper and lower modes equals the thickness of the required tile. Then the above model is quasi, the worktable turns, installs the remaining five to pay down the mold, all installs the upper and lower mold to be able to drive the pressure tile. First empty operation to observe carefully, there is no vibration, noise, oil window whether to oil, the parts of the movement is coordinated, all normal before the installation of molds, installation of molds, must cut off the power supply, with hand-moving motor belt or large gears, C-section purlin machine to make the table, and the slide to the highest point, It is best to use an object to support the table and the bottom of the sliding seat, to prevent the natural whereabouts of sliding seat, resulting in accidents.